FLOW Designs Falcon FGX Front Lip Splitter Extensions (Pair)

FLOW Designs Falcon FGX Front Lip Splitter Extensions (Pair)MADE FROM SCRATCH RESISTANT ABS PLASTIC INSTALL DOES NOT REQUIRE BUMPER REMOVAL Our adjustable front lip splitter extensions bolt directly onto our FGX front lip splitter thanks to the pre pressed in threaded brass fittings. Fitting kit is provided to ensure perfect fitment and can be adjusted to your liking. Adjustments can be made anywhere between 5mm 20mm on each side increasing the overall width up to 50mm! Our Falcon FGX body kit range range

for the engine version: 316i / 318i / 320i / 320si / 323i / 325i / 330i / 335i / 316d / 318d / 320d / 325d / 330d / 335d

not asymetric like the original rubber bushings

Shoulder to shoulder tape

BMW M4 (F83) – 2021–present (Competition & CS models)

This value is a rough estimate and can vary based on the climatic conditions and the ground on which the vehicle is used (sand

and throttle response suffers when the valve vents more than it should in situations where you are not fully lifting the throttle

SuperPro Camber Adjusting Bolt Kit

a  fusion of world-renowned Nitron quality and attention to detail

Front Splitter Lip Carbon Pre-Preg

BMW F87 M2 Competition 2018-2021 (inc

Does NOT Fit Coupe or Estate/Wagon Models

This means you can run a lower nose