2.5" OD X 6" Long

2.5" OD X 6" LongStandard aluminum intake tubing. 6061T6 alloy . 065 wall thickness. Cuts easily with a hack saw. About 1 1 2 inches on each end goes inside an intake hose (minimum 1 inch). Mill finish (as it arrives at our location from the mill after traveling on a truck and being handled several times) may have minor defects and small scratches, but no dents or major defects. Made in USA.

5" intake tube fits in the hole

This reducing 90-degree intake elbow can be used any place where you are connecting a 5" OD tube and a 4" OD tube

Recommended clamps are 94100-0400 on the big end and 94100-0350 on the small end

Navistar / International 439311C1

This reducing insert adapts a 3" ID intake hose to a 2

You install it in the end of the 2-1/2" rubber elbow or hump hose

Recommended clamps are 94100-0600 on the small end and 94100-0750 on the big end

This 3-1/2 inch 90-degree intake hose can be used where you have two 3-1/2" OD tubes and you need to make a 90-degree bend

Recommended clamps are 94100-0500

This reducing hump hose connects 8" OD and 6" OD intake tubes

Special tight-weave aramid reinforcement can handle more pressure and lass longer than other brands

125 wall thickness