Water Pump Pulley Cap - Machined

Water Pump Pulley Cap - MachinedThis cap is designed to fit most Ford water pump pulley mounting configurations of the Small Block (SBF) and Large Block (FE) engines from the 1960s to the 1990s. For those running electric fans (not the factory water pump mounted traditional fan), this Cap is a great way to jazz up and secure the pulley on the front of your water pump. These caps are CNC machined from 5 8" thick 6061 Aluminum rod bar, here in the United States. The back side of the

You will need to reuse the existing nuts that secured your seats to the car for these extension pieces when you install them back into your car

minimalist finish

Please do your own research to determine if you can use this toggle switch to override the operation of your electric fan(s)

that's why it's easier to measure the distance of the bolt holes themselves

and some other models

This template is designed to be used on both the driver passenger side

This kit combines three critical chassis upgrades for the 1967 and 1068 Classic Mustang for massive improvements over the stock car

check out the Round Tube shape (Gen 2) here

The ground wire from the relay connects to the center post of this toggle switch

and an M10x1

I feel the stock wheel caps provided by American Racing are too large and stick out too far

Template moves Upper Control Arm down one inch